Design and Verify RF Transceivers for RADAR Systems
Register for this webinar by completing this form.
This webinar is offered at the following date/time(s):
20 Aug 2013 9:00 AM EDT
20 Aug 2013 2:00 PM EDT
In this webinar, you’ll learn how to design and simulate a RADAR RF transceiver using MATLAB® and Simulink® products. Several aspects of modeling and simulating RADAR systems will be covered, including:
• Waveform and test bench creation using Communications System Toolbox, DSP System Toolbox and Phased Array System Toolbox
• Top-down design of the RADAR receiver architecture and progressive refinement of the RF specifications
• Simulation of Ultra-Wideband FMCW signals in the RF domain for range and Doppler estimation
• Tradeoff simulation speed and modeling fidelity using equivalent baseband and circuit envelope simulation techniques
• Estimate the impact of the RF front-end including S-parameters, noise, non-linearity on the overall system performance
• Waveform and test bench creation using Communications System Toolbox, DSP System Toolbox and Phased Array System Toolbox
• Top-down design of the RADAR receiver architecture and progressive refinement of the RF specifications
• Simulation of Ultra-Wideband FMCW signals in the RF domain for range and Doppler estimation
• Tradeoff simulation speed and modeling fidelity using equivalent baseband and circuit envelope simulation techniques
• Estimate the impact of the RF front-end including S-parameters, noise, non-linearity on the overall system performance
Please allow approximately 60 minutes to attend the presentation and Q&A session.
About the Presenter: Dr. Giorgia Zucchelli is the product marketing manager for RF and mixed-signal at MathWorks. Before joining MathWorks in 2009 as an application engineer focusing on signal processing and communications systems with specialization in analog simulation, Giorgia worked for two years at NXP Semiconductors on mixed-signal verification methodologies. Before then, she worked for Philips Research, where she contributed to the development of system-level models for innovative telecommunication systems. Giorgia has a master’s degree in electronic engineering and a doctorate in electronic engineering for telecommunications from the University of Bologna. Her thesis dealt with modeling high-frequency RF devices.
About the Presenter: Dr. Giorgia Zucchelli is the product marketing manager for RF and mixed-signal at MathWorks. Before joining MathWorks in 2009 as an application engineer focusing on signal processing and communications systems with specialization in analog simulation, Giorgia worked for two years at NXP Semiconductors on mixed-signal verification methodologies. Before then, she worked for Philips Research, where she contributed to the development of system-level models for innovative telecommunication systems. Giorgia has a master’s degree in electronic engineering and a doctorate in electronic engineering for telecommunications from the University of Bologna. Her thesis dealt with modeling high-frequency RF devices.
Product Focus
- RF Toolbox™
- SimRF™
- Simulink®
No comments:
Post a Comment